How we realize your systems

All Trascar systems are designed in our department of mechanical electronic and software design. Every project is followed since its beginning by an assigned Project Manager in charge of the full development  of your systems by keeping a continuous relationship with customer.
Each system is faced in order to solve fully the logistic problems shown by customer, our system is customized same as making a dress.
TRASCAR takes especially care of Research and Development, which are basic for all realization to improve  continuously our systems.
Systems are assembled and tested by our technicians at the internal assembly division covering an area of around 5000 sqm. Our customers are always asked to attend the system tests.
System is then sent to the installation place at customer’s factory, where our team of technicians and a site manager perform its start-up and final test, even in this phase Trascar Project Manager is at customer’s side.

During start-up at customer’s factory our technicians perform training to production personnel or maintenance technicians about using system both as for the operation and safety applied.

The programming division of our factory can develop directly a software both on PLC and PC level. In the automatic lines weighing for box check, labeling for storage and the relevant product traceability with bar code and alphanumeric code or check of compliance can be made by direct correlation with the factory management software or using shared folders. Trascar technical software department is directly in charge of designing software, both on PLC and PC level, interfacing directly to customer’s management software.